- All (50)
- Coupons (45)
- Deals (5)
- Free Shipping (2)
Save up to 70% off at LANDS' END
Expired Warp 9 Racing Coupon Code
Related Warp 9 Racing Coupon Code
Warp 9 Racing FAQs
How to install the crf250l caliper bracket of Warp 9 Racing?
Warp 9 Racing recommends that you remove the two OEM Silver Factory bolts that hold the calipers to the front fork and set them aside. You will not reuse these bolts. The new bracket consists of 4 new bolts and 2 flanged. Two bolts without flange (low profile head) will be screwed into the caliper bracket from the inside of the fork leg and the two bolts with flange will go through the holes that weld the column to the bracket which are located at the rear of the bracket, and then screwed into the OEM caliper.
How to install the KTM SM bracket of Warp 9 Racing?
Warp 9 Racing recommends using a 10 mm sleeve to loosen the bolts of the original caliper assembly from the front fork leg. Once the caliper is released from the front fork leg you need to remove the brake pads. First remove the brake pin cap screw with a flat blade screwdriver, then the brake pin (the brake pin holds the brake pad in the caliper). After removing the cover screw, you will see a 6 mm socket bolt remove it.
How to install Warp 9 Racing's DR650 caliper bracket?
Warp 9 Racing recommends loosening the bolts of the original caliper assembly from the fork legs. There is no need to untie the brake cable or anything, just remove the caliper from the fork leg. Once the caliper is released from the front fork leg and you must remove the mounting bracket part because this is the part to be replaced. You should also check the stop pin and make sure that there are no grooves or obvious wear on the pin. When you release the brake lever and the groove or wear on the pin will prevent the brake pad from falling off the rotor.
How to install additional bracket for Warp 9 Racing?
Warp 9 Racing recommends that you put the bicycle on the bicycle rack for easy installation. If the bicycle has a plastic frame guard, remove it temporarily. Remove the OEM bolts from the lower chain slider. Insert the long bolt into the hole at the bottom of the bracket and slide the aluminum washer to the back of the bracket just inserted into the bolt. This washer bolt will be screwed into the OEM chain slider bolt you removed. Observe whether the machined notches on the bracket are installed on the ridge of the frame.
About Warp 9 Racing
Parts & Equipment should be updated with the increasingly rich function of cars and motorbikes. The team of Warp 9 Racing will guarantee both the quality and the reasonable price of its goods. Here, you can find high-quality Parts & Equipment. If you want to experience a better shopping experience, use the 50 Coupon Code listed on this page. Don’t miss the best time to save money, click on Warp 9 Racing's Coupon to buy Parts & Equipment now.